Rubber Feet Kit

Installation instructions for Rubber Feet Kit for UltraLite Pet Stairs

1) Make sure your kit includes four rubber feet and four screws. You will need a Phillips screwdriver to install the feet.

2) Invert the stairs and locate the four 1� diameter depressions on the underside of the Stairs. Each depression has a spot in the center to start the screw. It is easier to insert the screws if you first drill out (use 3/32� or smaller bit) the center of each depression.

3) Working one at a time, center the rubber feet in the depressions and insert the screws. Be aware that it if the hole has not been pre-drilled, it will take some force to screw into the plastic. Be careful not to over-tighten the screw as it is possible to strip out the plastic wall.

4) Once all four feet are installed, revert the Stairs and use normally. The feet might attract dust over time and lose some of their non-skid performance. In this case, simply wipe the feet clean with a wet cloth or mild cleaner.